Fitting the bow freshwater tank and forward seating area and making lockers either side of the tank.

The job was to decide the position of the water tank and then sort out the supports to go under the tank 

Supports screwed down into position and the webbing straps to hold the tank in position where the framework was being built around the tank

First part of the framework screwed in position  

Setting out the plywood to make the base for the seating area 

first part fitted into position just leaving the ends to lead the filler pipe through before fitting the last piece of plywood to finish the top off at the end

The two pieces now fitted and now ready for the front panel 

Front panel made up and fitted and then just the rail along the front to stop the cushions from coming off the top of the seating area.