Bedding the aft floor bearers and screwing the engine beds into the floor bearers

After shaping the bottoms of the aft floor bearers at the end of the engine beds, they were bedded on a thickened mix of epoxy and set them on to the hull.

Using the spreader panels to keep the engine beds in the correct position while the epoxy cured and then glass in the floor bearers and then once the floor bearers are glassed into position do the same to the engine beds.Thickened epoxy and then glassed into position.

Once the engine beds are glassed in position fit the steel angles on to the engine beds and so out the fitting of the stern tube.