Picnic Boat floor bearers going in and leveling the floor through the boat to fit the new floor to once the floor bearers are glassed in

Now the inner part of the new stern tube is glassed into position the aft floor bears can now be bedded in position with thickened epoxy and once this is cured the floor bearers will be glassed into position and will help strengthen the hull from flexing 

In order to keep the floor bearer in the correct position a couple of thin battens have been fixed to the top to hold the floor bear in position while the epoxy goes off

The outer part of the stern tube is now in position and now needs the stern tube surrounded by a new deadwood to hold in position and take any holding and to protect the propeller

The view of the inside of the boat with the engine beds all glassed in position and the two short floor bearers fixed in position with epoxy and ready to be glassed in when the aft floor bearer epoxy as cured and then the lot will be glassed in at the same time