Thursday, 4 March 2021

fitting the keel infill and outboard pad and setting up the forward and aft seats

In order to fix the floor boards down in position, there was a timber infill fixed in the keel channel which was epoxied in position.


The outboard inner pad shaped and fixed in position with thickened epoxy 


The forward seat being set up in position with the aid of a chock at the base and leveled up 


The last part of the infill glassed over to seal in the infill



The outboard pad being glassed over and then the aft seat can be put in position using the same method as the forward seat with a chock temporarily fix to the infill, so while it is glassed in position it will not move out of position 


The aft seat like the forward seat masked up ready for the seat to be glassed in position and then the matting can be trimmed  


 

No comments:

Post a Comment