Google+ Followers

Thursday, 26 January 2017

Progress on the work's Dinghy

Shaping the transom pad to fit, before getting ready to grind the inside of the hull ahead of the marine plywood pad.


Putting a tie brace into the hull to stop it flexing while glassing in the transom pad and the aft seat bulkhead.


Final fitting of the seat bulkhead before doing the grinding to glass this bulkhead in place at the same time as doing the transom pad.


Setting out the position of the forward locker floor and then making a pattern to fit the position set out by the two bits of batten at the correct height. 


No comments:

Post a Comment