Having made the patterns for the seat backs for the Pearly Miss it was time to make the final seat backs out of 12mm plywood, each of the tops of the seats are the camber of the deck in each of the positions they are in with the correct amount of angle laying aft in it of their positions the plywood will be coated with primer and then undercoat and finally white gloss marine paint after they are given a batten along the top and bottom edges to strengthen up the plywood and where the back will be covered with foam and vinyl
Now that the bilge keels have been covered with fibreglass it i time to move on with doing the inside of the hull and make and fit the gunwales and inwales and fix the seat blocks in position and make a new centre thwart.
The mahogany trims for the Pearly miss getting their final thinned coat of varnish before they are rubbed down and iven a final coat of full strength varnish before they are screwed to the inside face of the cockpit.
The new battery box for the Pearly Miss getting its first cot of grey bilge paint a few more coats of paint to go on before that is refitted under the aft deck.
No comments:
Post a Comment