Working on the Fairline Carberra we have in the boatyard at present for a refit and to have the engine put back in the engine after a major rebuild of the engines.

Having cleaned off all the old cabin linings which were in a poor condition it was time to clean the whole area ready to put back the headlining panels and reline the walls of the under cockpit sleeping cabin.

This was the first half of the floor and sides getting a good cleaning.

This photo show the state the floor and sides were in before we started cleaning off the old glue and other dirt on the floor and sides

The two side panels refitted after having to cut holes in the side linings to get at the old 240-volt wiring which ws household grade wire and not marine grade which it is replaced with now and the 240-volt wiring is up to spec.

A few hours work and it is looking a whole lot better and just have to refit the engine shift cables back and the hole of this area can be refitted and it can look like it did before apart from being relinined with carpet side linings.

The whole of the area cleaned and ready to go.

Time to have fun relining the cabin and lining out the area and putting it back to together.