The mock up of the helmsman seat to gauge it correct height and position from the steering wheel and engine controls. Now that it is made the measurements can be taken off and made out of teak faced marine plywood.
The first coat of flow coat put on the aft bulkhead and the hull. Once it is coated again it will the teak faced plywood bulkheads covered in Formica so the compartment can be used as a shower and toilet compartment.
The next job is the cockpit is going to be the aft locker lids which need edging with mahogany and fixing down in position ready to be covered with the same covering as the floor.
No comments:
Post a Comment