Tuesday, 3 July 2018

Making patterns for plywood deck and cutting out plywood ready to dry fit later

First job this morning was to make all the patterns for the plywood decking out of 3 mm plywood and then mark off the edges of the cabin side and the hull edge


All the patterns made and now ready to cut the plywood out to make the deck panels 


Marking out the deck panels 


Cut roughly to size with a small amount of trimming to be done to make them fit the edges of the coaming and cabin sides and the top of the transom


One side deck cut and just needs cutting at the ends to fit the other piece of plywood and by over a deck beam as well


Just one more panel to make for the port side deck and then on to the foredeck panel



No comments:

Post a Comment