Finally got to the end of the sanding apart from spot fine filling areas to fair up low spots on hull.

The top edge of the hull the Cove line and the water line are all sanded down ready to get it prepared to paint the hull

There are a few areas which need a bit more fine filling 

Most of the hull is now ready,just got to clean up the area round the boat and get rid of any dust laying around the boat

Going round the hull doing a few more areas of spot filling 

The biggest areas are where the chain plate are glassed and bolted through the hull which have been the biggest area that needed filling over the course of applying the Hi-Build epoxy primer and then sanding the hull back to a smooth finish 

The other job done this week was to move the boat up the workshop to get access to the transom so it can be painted a lot easier than leaving where it as been for a long time.