Tuesday 3 October 2017

working on getting the Hull jamed in its mould out of the mould

Removing matting from the where the bow seat was to make the moulding flex enough to move out of the mould


Doing the same to the aft seat area and taking out wood in the keel area


Leveling up the dinghy in the cradle to ensure the seats get glassed in level


Glassing in the reinforcement plywood for aft seat 


Trimming the bow seat moulding to fit the inside of the hull


Glassing in the transom pad to strengthen up the transom of the dinghy to take a reasonable size outboard motor should one be fitted by its new owner


Ensuring the dinghy stays level while glassing in  the bow and aft seats.


No comments:

Post a Comment